jcaplins
Well Known Member
Is there a way change what MAP sensor the SDS system is setup for?
I believe I have a 2 bar sensor. It is reading 2" hg to high and is pretty much 2" too high through the full range compared with another sensor I have connected to the GRT EIS. So I want to replace it.
I'm not running any boost so I think a 1 bar would be the best fit. When I plug in the 1 bar sensor the SDS reads ~60"hg... so any way to correct this with the push of a few buttons?
Thanks,
I believe I have a 2 bar sensor. It is reading 2" hg to high and is pretty much 2" too high through the full range compared with another sensor I have connected to the GRT EIS. So I want to replace it.
I'm not running any boost so I think a 1 bar would be the best fit. When I plug in the 1 bar sensor the SDS reads ~60"hg... so any way to correct this with the push of a few buttons?
Thanks,