I've been scratching my head for a couple days now on this step.
Step 1 says to mark the skin edges... plural... on the trailing edge and trim to the line. This would leave a portion of the lightening hole visible on the top, but not the bottom.
Figure 2 clearly shows no lightening hole on the end at the top after trimming.
Thinking I should trim at 90 degrees, 1/8" or so below the skin edge (past the mark) and remove the partial half moon lightening hole. Directions very unclear on this.
I am brand new and maybe overthinking it?
Step 1 says to mark the skin edges... plural... on the trailing edge and trim to the line. This would leave a portion of the lightening hole visible on the top, but not the bottom.
Figure 2 clearly shows no lightening hole on the end at the top after trimming.
Thinking I should trim at 90 degrees, 1/8" or so below the skin edge (past the mark) and remove the partial half moon lightening hole. Directions very unclear on this.
I am brand new and maybe overthinking it?