Hello All,
Has anyone successfully installed a roll servo in a flying RV3A?
I'm finally ready to install my Dynon roll servo in my RV3A. The plane is long sealed up and access is tight.
The aileron bell crank access panel is quite small. I can hardly fit my hand in there. I think installing the large servo would be nearly impossible.
Under the seat offers very little room too. I would need to make more serious mods to get it in there than I'm really comfortable with.
The wingtip seems like the best choice but not sure about the extra long pushrod back to the bell crank.
Does anyone have experience with this install?
Thanks
Has anyone successfully installed a roll servo in a flying RV3A?
I'm finally ready to install my Dynon roll servo in my RV3A. The plane is long sealed up and access is tight.
The aileron bell crank access panel is quite small. I can hardly fit my hand in there. I think installing the large servo would be nearly impossible.
Under the seat offers very little room too. I would need to make more serious mods to get it in there than I'm really comfortable with.
The wingtip seems like the best choice but not sure about the extra long pushrod back to the bell crank.
Does anyone have experience with this install?
Thanks