wirejock
Well Known Member
I am really diggin' this Harbor Fright Black Widow HVLP HTE gun. These parts were the first big job done with it.
24oz of Kirker EnduroPrime 2K epoxy. 2 coats 1 hour apart. 24 hour cure
Wet sand 400
24oz of Kirker UltraGlo Single Stage Urethane. 3 coats one hour apart.
Both were reduced with Kirker slow speed by 12% plus Kirker fish eye drops. Calculator is on my blog.
Yes, I know. Black is so bad, but it's my airplane.
Anyway, the Black Widow is awesome. I got it dialed in and it sprayed so nice. It's a copy of a SATA 5000. SATA parts are supposed to work. I'll let you know. I am ordering a air fitting for it. I don't like the swivel.
3M PPS cups work great with the HF adapter.
Cut & buff should take care of some minor issues.
24oz of Kirker EnduroPrime 2K epoxy. 2 coats 1 hour apart. 24 hour cure
Wet sand 400
24oz of Kirker UltraGlo Single Stage Urethane. 3 coats one hour apart.
Both were reduced with Kirker slow speed by 12% plus Kirker fish eye drops. Calculator is on my blog.
Yes, I know. Black is so bad, but it's my airplane.
Anyway, the Black Widow is awesome. I got it dialed in and it sprayed so nice. It's a copy of a SATA 5000. SATA parts are supposed to work. I'll let you know. I am ordering a air fitting for it. I don't like the swivel.
3M PPS cups work great with the HF adapter.
Cut & buff should take care of some minor issues.