So here's my issue. When completing page 16-3, it tells me to rivet a K1100-08 nutplate to the aft holes of the skin. I pulled out one of my 224 K1100-08 nutplates that I inventoried only to discover that the #8 dimple of the skin does not fit into it. After a little research I discovered that the difference between a K1000 and a K1100 is the K1100 has a bigger opening to accept a skin dimple. Van's sent me 224 K1000-08 nutplates -not K1100-08 as the bag was labeled. This one nutplate is not a big deal -I can get another. What about the 56 K1100-08 nutplates that were supposed to be installed on each spar though? At the time, I had no idea I was actually installing K1000-08's Is that going to cause me a problem later on? Please tell me I don't need to drill all of those out. I've emailed Van's but haven't heard back yet. I hope they will make this right and send me the correct ones.