Stockmanreef
Well Known Member
This might be a dumb question, but.....
I am attaching the nut plates for the access plates. The plans states that one should use K1100-08D. well there certainly not enough of those in the kit. I ran out at after 2 plates.
I have a whole bunch to the K-1100-08. Not dimpled. And I can't seem to find where these would be used, since I am almost done with the wings. so I assume that I am to dimple these and use them.
Why in the world would Van's not put in the correct number of the K-1100-08D?
Are they that much more expensive?
I am attaching the nut plates for the access plates. The plans states that one should use K1100-08D. well there certainly not enough of those in the kit. I ran out at after 2 plates.
I have a whole bunch to the K-1100-08. Not dimpled. And I can't seem to find where these would be used, since I am almost done with the wings. so I assume that I am to dimple these and use them.
Why in the world would Van's not put in the correct number of the K-1100-08D?
Are they that much more expensive?