I was installing my vernier mixture cable yesterday, and needed to shorten it (Bowden style wire cable from ACS), so without remembering the instructions that came with it that say to not pull the handle out past a certain point because the ball will fall out, I did exactly that, and the ball did exactly that as well. It fell into my open seat ribs, and after a few minutes of digging I found it, cleaned it, and set it in a safe spot. When I had finished with the cable and was ready to install it, I picked it up again to reinstall it and promptly fumbled it, sending it flying across the shop and into a pile of junk.
I spent a couple hours on hands and knees looking for that little POS, but it's permanently gone. Does anyone happen to know what size ball bearing that is, and where I can get a replacement other than buying a new cable just for that part?
I spent a couple hours on hands and knees looking for that little POS, but it's permanently gone. Does anyone happen to know what size ball bearing that is, and where I can get a replacement other than buying a new cable just for that part?