Experimental Chaos
Well Known Member
Building Tip
An easy way to evenly space the 6 rivet holes around the control pushrods is screw a 6 sided bolt into the end and use a square to line a flat up perpendicular to the table of your drill press, and drill the hole, then just index it to the next flat. If you have your control tube set in a V block, you can also set a stop for the head of the bolt to rest against so all the holes are the same distance from the end.
an old machinist trick
An easy way to evenly space the 6 rivet holes around the control pushrods is screw a 6 sided bolt into the end and use a square to line a flat up perpendicular to the table of your drill press, and drill the hole, then just index it to the next flat. If you have your control tube set in a V block, you can also set a stop for the head of the bolt to rest against so all the holes are the same distance from the end.
an old machinist trick
Last edited by a moderator: