In my purchased RV9 I have Aero LED Pulsar 12V LED wing tip NAV/Strobes and an Aero LED Sundial synced. The average amperage for the wings is 1.2 with a peak of 9.9. For the Sundial it's .52 with a peak of 4. The wire is 22 gauge M27500-22TG3T14, a 3 conductor cable with tin coated Cu Round shielding. AC 43.13-1B says the fuse for 22 gauge wire should be 5 amp. I keep blowing the 5amp fuse after several hours of flight. Is the combined peak amperage of the three strobes (13.9) too much for the 5A fuse and the 22 gauge wire and is that what is likely blowing the 5amp fuse? If I connect the tail strobe wire to the white light in the tail to get it off the same wire as the wing strobes will that help? What if I just disconnect the sync wire so they flash on their own and there isn't a combines peak of 13.9? Or what if I just disconnect the tail strobe? Or do I need to rewire with 18 gauge wire which takes a 10 amp fuse? Or might I have a power to ground problem with a stray wire strand?