Help! Ihave problems with Skyview detect. I go into detect page and Skyview detects no devices. I then use 9 pin wires supplied by Dynon and for instance go directly between Skyview and for examples the EMS module. Then thru setup Skyview detects the EMS modue. Then I reconnect Skyview thru RV12's harness and the EMS module works normally. So I fiquire that the wires are correct in RV12 wiring. Then I will go back into setup to detect other devices in network and the system again detects no devices. If I put 9 pin wires into the ADAHRS unit and go directly between SKYview and ADAHRS, the system then detects the module and then I hook up RV 12 wiring and system works. If I go back into setup, then detect other devices on network it shows no devices again. Called Vans and Dynon tech with no solutions from either.
Pulling out my hair and other Russians hair too.
Pulling out my hair and other Russians hair too.