I am currently working on seat upholstery on the 10. I see several of the bottom seat cushions are held via velcro-ed sheets of material that wrap around the round tubes and stick to the velcro on the bottom of the cloth seat support. I would like to follow this design, but it looks like I will have a problem securing the front velcro once the seat handle is installed (I need the cushion out in order to tighten the 4 nuts). With the handle installed and seat slide full forward, I can barely get my fingers under the seat to reach the bottom velcro. It seem like it may be possible to attache the front strap before seat handle installation, but it looks like the bottom cushion may not be able to be forced under the seat back cushion once the front strap is attached.
Wondering how others are dealing with this. My alternative is to use the velcro on the top of the cloth seat support and secure to velcro on cushion bottom.
Thanks,
Larry
Wondering how others are dealing with this. My alternative is to use the velcro on the top of the cloth seat support and secure to velcro on cushion bottom.
Thanks,
Larry
Last edited: