rvanstory
Well Known Member
I have a question about prepping parts with PreKote for priming with SW P60G2 Industrial Wash Primer.
Previously I have been sanding (scuffing) all shiny surfaces with Scotchbrite pads to a dull finish in order to get good adhesion of primer and then washing with Lacquer thinner. Primer sticks great, but all this sanding and washing with lacquer thinner is a bit of a pain.
As I read about PreKote, it's not clear to me if I can avoid all this tedious sanding before washing with PreKote. If I simply wash with PreKote and scrub (lather it up) with scotchbrite pad as per instructions, does this properly prep the factory surface without having to sand all the parts to dull finish by hand before wiping down?
It's not clear to me from other posts if I can avoid this initial "sanding" of the parts before using PreKote. Can someone give me their insights?
Previously I have been sanding (scuffing) all shiny surfaces with Scotchbrite pads to a dull finish in order to get good adhesion of primer and then washing with Lacquer thinner. Primer sticks great, but all this sanding and washing with lacquer thinner is a bit of a pain.
As I read about PreKote, it's not clear to me if I can avoid all this tedious sanding before washing with PreKote. If I simply wash with PreKote and scrub (lather it up) with scotchbrite pad as per instructions, does this properly prep the factory surface without having to sand all the parts to dull finish by hand before wiping down?
It's not clear to me from other posts if I can avoid this initial "sanding" of the parts before using PreKote. Can someone give me their insights?