David_Nelson
Well Known Member
I'm in the final stages of forming the intake plenum that connects Van's FI
snorkel to the AFP servo. Before I start laying down fiberglass, are there any
areas I should rework from an airflow perspective?
Right now, my concern is the sharp 90 deg turn into the AFP servo. Would it be
better to contour the outside corner a bit or leave as is? I don't have any
clear pictures of the inside corner but it makes an even sharper turn.
Thanks,
/\/elson
snorkel to the AFP servo. Before I start laying down fiberglass, are there any
areas I should rework from an airflow perspective?
Right now, my concern is the sharp 90 deg turn into the AFP servo. Would it be
better to contour the outside corner a bit or leave as is? I don't have any
clear pictures of the inside corner but it makes an even sharper turn.
Thanks,
/\/elson
Last edited: