On page 24-05 (I have the rev dated 10/26/11) it clearly shows three snap bushings (SB375-4) going into three holes in the flange at the bottom of F-1207D-L. However, my F-1207D-L only has two holes.
What are these snap bushings for? (I don't have the finish kit yet, so looking ahead in my plans provided no info.)
Do I need three of them, or is two sufficient? Do I need to drill a third hole?
Thanks!
What are these snap bushings for? (I don't have the finish kit yet, so looking ahead in my plans provided no info.)
Do I need three of them, or is two sufficient? Do I need to drill a third hole?
Thanks!