Omega232Devils
Well Known Member
Ok guys, I have done a lot of research (including search function) and have talked to several people offline. A lot of great advice and I appreciate it.
I am very close to pulling the trigger on upgrading to dual P-Mags and my only concern is the tach signal from the P-Mag communicating with my VM1000 (NOT the 'C' model).
P-Mag: I know the P-Mag has the ability to send out tach signal in 12v and 5v (with supplied jumper) and can be programmed via EICAD to push 1 or 2 pulses per revolution.
VM1000: Accepts 5v tach signal. Some DPU versions have a jumper (JP2) inside the DPU that cuts tach output in half (presumably for 2 pulse per revolution systems).
So here is my question:
1) Has anyone made the P-Mag tach signal successfully communicate with VM1000? (If so, what was involved)
2) The jumper inside the DPU, is it necessary to change the tach output in the DPU if I can reduce the P-Mag tach signal from 2 pulses to 1 pulse per revolution?
Just looking for some clarification before I pull the trigger!
Thanks
Dan
I am very close to pulling the trigger on upgrading to dual P-Mags and my only concern is the tach signal from the P-Mag communicating with my VM1000 (NOT the 'C' model).
P-Mag: I know the P-Mag has the ability to send out tach signal in 12v and 5v (with supplied jumper) and can be programmed via EICAD to push 1 or 2 pulses per revolution.
VM1000: Accepts 5v tach signal. Some DPU versions have a jumper (JP2) inside the DPU that cuts tach output in half (presumably for 2 pulse per revolution systems).
So here is my question:
1) Has anyone made the P-Mag tach signal successfully communicate with VM1000? (If so, what was involved)
2) The jumper inside the DPU, is it necessary to change the tach output in the DPU if I can reduce the P-Mag tach signal from 2 pulses to 1 pulse per revolution?
Just looking for some clarification before I pull the trigger!
Thanks
Dan