The cutout in the U-1013C-L and R mounting brackets that fits over the axle washers has some play in them (up and down play). Is this OK? Furthermore, the plans calls for three washers under the bolt head and nut. They are AN 960-616 and AN-960-616L, and outside to these washers is a larger diameter washer 062-25783054. The combined height of the 616 washers is greater than the thickness of the mounting bracket, with the result that there is up and down play from the mismatch of cutout and 616 washer diameters AS WELL as the bracket not held down by the larger washer. Does not seem right to me.
As a side, I have the MATCO nose wheel installed.
What did you guys do gain access to the nose wheel valve?
Thanks.
Johan
As a side, I have the MATCO nose wheel installed.
What did you guys do gain access to the nose wheel valve?
Thanks.
Johan
Last edited: