kbehrent
Well Known Member
I have the ADS600B and I'm following the "ADS600-B to AFS Interconnect Diagram" from Navworx to connect to my AFS 4500, GTX-330 and GNS-530W.
On the diagram, it calls out a connection from pin #35 (suppression output) on the ADS600B to "Transponder suppression input" on the transponder. It does not provide a pin assignment for the transponder. In looking at the GTX-330 install manual, I see there is a "External Suppression I/O" on pin #31. Is this the correct pin to connect too and what is the purpose?
I do know about the need to connect pin #33 on the ADS600B to a RS-232 output on the transponder for remote control, but don't recall anybody discussing the use/need for pin 35.
On the diagram, it calls out a connection from pin #35 (suppression output) on the ADS600B to "Transponder suppression input" on the transponder. It does not provide a pin assignment for the transponder. In looking at the GTX-330 install manual, I see there is a "External Suppression I/O" on pin #31. Is this the correct pin to connect too and what is the purpose?
I do know about the need to connect pin #33 on the ADS600B to a RS-232 output on the transponder for remote control, but don't recall anybody discussing the use/need for pin 35.