Fitting the two right and left lower firewall brackets. The F801-E side angle does not nest properly in the weldment. I nested it in the right position, but it seems the paint on the weldment along with the amount of angle material on the F801-E keeps the flange from nesting flat in the weldment.
My choices are to strip the paint from the weldment and/or relieve the edge of the F801-E so it doesn't bind in the corner.
I don't know what later step needs hole distance at the bottom of the F801-E side angle if I remove material to make it nest properly.
Any ideas?
My choices are to strip the paint from the weldment and/or relieve the edge of the F801-E so it doesn't bind in the corner.
I don't know what later step needs hole distance at the bottom of the F801-E side angle if I remove material to make it nest properly.
Any ideas?
Last edited: