danielhv
Well Known Member
Ok, Im working on attaching E-703/E-704 to the E-702 spar... Its a very tight spot... and after several squeezing attempts, bucking attempts, and a very poor attempt at back riveting... every rivet lays over sideways... Needless to say, the holes are showing the abuse! My plan is to put a double made out of .032 on both sides of the spar and use longer rivets... Of course I'll debur the jagged holes as best as possible, and re-prime... but I wanted to see if anyone else had any good ideas before I drill extra holes in the spar.
There will be two more rivets right behind the two clecos in this pic:
There will be two more rivets right behind the two clecos in this pic: