bruceh
Well Known Member
I need to get the remaining clips for the connection between the center and forward baffle sections fabricated and riveted in place. The instructions are pretty vague about where to trim the center section pieces with respect to the cowling. Do I line up the forward part of the center section with the cowling inlet and cut on the blue line? I know to leave some room for the baffle gap seal material on the side. I don't have the upper fiberglass inlet ramps glued on to the top cowling yet, so I know there is still some trimming down the road.
I had to notch the lower inlet ramp on the left side of the photo here to clear the starter ring gear and alternator belt pully. Is there any reason to leave this much floor here, or can it be trimmed back to the vertical center baffle pieces?
I had to notch the lower inlet ramp on the left side of the photo here to clear the starter ring gear and alternator belt pully. Is there any reason to leave this much floor here, or can it be trimmed back to the vertical center baffle pieces?