PaulvS
Well Known Member
Does anyone have any hints for how you went about crawling into the tailcone during construction? I'm at that stage now for my -6A build where the tailcone second top skin needs to be fitted. It's too far to reach inside for drilling and riveting.
I'm thinking that maybe some plywood or particle board cutouts to fit inside and over the belly skin sections would provide enough support and protection to be able to kneel inside.
Unfortunately the construction manual doesn't offer any suggestions! The canoe is supported on stands at the recommended height.
Pics attached of the setup as it stands.
TIA
I'm thinking that maybe some plywood or particle board cutouts to fit inside and over the belly skin sections would provide enough support and protection to be able to kneel inside.
Unfortunately the construction manual doesn't offer any suggestions! The canoe is supported on stands at the recommended height.
Pics attached of the setup as it stands.
TIA