Not sure which heat shield material you're using. If it's the self adhesive type similar to the Heat Shield Mat that we carry, you just clean the area, sand it if needed to make it smooth, cut and press to install.
For the best installation, you then run a small bead of RTV or ProSeal around the edges to seal out any oil or water infiltration.
Other types are similar, but follow any other specific instructions provided by the mfg.
Not sure which heat shield material you're using. If it's the self adhesive type similar to the Heat Shield Mat that we carry, you just clean the area, sand it if needed to make it smooth, cut and press to install.
For the best installation, you then run a small bead of RTV or ProSeal around the edges to seal out any oil or water infiltration.
Other types are similar, but follow any other specific instructions provided by the mfg.
Any special type of paint used inside the cowl?
Dan, I can't tell. Are those all metal nutplates around the exhaust area....