Mike S
Senior Curmudgeon
So, how many of you with GRT systems have wondered about the best way to install the Hall Effect sensor that is used to sense the amp meter input???
I was concerned about just letting it bounce around back behind the panel, so I called the company, and was told there is no specific way to do it.
I had thought of just jamming a bunch of sponge rubber in around the wire, zip ties in a criss-cross pattern, ETC.
So, after sitting back and enjoying a glass of white Zin, while I pondered the issue, it suddenly came to me.
And, here it is put together.
Yep, the wine bottle cork is just the right size!!!
I drilled the hole in the cork under sized, wanted it to grab onto the wire, not slide around.
I will use a bit of "Shoe Goo" on final install just to make sure it all stays put.
I was concerned about just letting it bounce around back behind the panel, so I called the company, and was told there is no specific way to do it.
I had thought of just jamming a bunch of sponge rubber in around the wire, zip ties in a criss-cross pattern, ETC.
So, after sitting back and enjoying a glass of white Zin, while I pondered the issue, it suddenly came to me.
And, here it is put together.
Yep, the wine bottle cork is just the right size!!!
I drilled the hole in the cork under sized, wanted it to grab onto the wire, not slide around.
I will use a bit of "Shoe Goo" on final install just to make sure it all stays put.
Last edited: