rapid_ascent
Well Known Member
I purchased a Grove reservoir to replace the standard Vans unit. I then got a stainless AN elbow fitting which I plan to use with the reservoir. When I started threading the fitting in it seemed to bottom out before it was threaded in that far or tight. I decided to stop at that point and seek out help from VAF. I don't think I want to keep trying to thread in the fitting. I'm wondering if I used thread sealant that will be sufficient or do I need to take some other action. The threads seem fairly loose so I'm questioning whether the sealant alone would be a good solution.
I'm a newbie with regard to all of the plumbing stuff so excuse this question if its obvious to some of you.
I'm a newbie with regard to all of the plumbing stuff so excuse this question if its obvious to some of you.