A little background, I have 120 hours now and love the plane and what it does. I had Anti Splat Aero do all 3 tires bearing and balance mod, I'm lazy and don't want to pack wheel bearings again. the mod works as advertised and the plane was butter smooth, couldn't be happier. My problem started at around 110 hours and over 120 landings, my right main was starting the shimmy and vibration issue I see others have had. Upon inspection I noticed my tire on that side the tread was worn off the outside edge, I rotated the tire on the rim thinking it had too much drag from the tread being gone causing the main gear to oscillate fore and aft and causing the vibration. This helped but did not fix the issue, so like others before I fabricated an Oak wood gear leg stiffener and that fixed the problem. I was not happy with the fix as it also caused the leg to be a little stiffer in the up and down motion also, so I started playing around and came up with a solution that works for both problems. using left over fiberglass and carbon fiber I had, I laid up 10 layers of 3" wide glass cloth with a single layer of carbon on each side. After cure I cut it in half leaving me two pieces 22" long x 1.5" wide and close to 3/16" thick. I then attached the pieces to the back side of the gear leg with 7 stainless steel Adel clamps, this allows the gear leg to still travel up and down with very little restriction and also stop all fore and aft shimmy. It all fits nicely under my gear leg fairings after I cut off the rubber strip on the top and bottom of the clamps, hopefully my photos attach and make this a little better to understand.