I'm wiring up the OAT probe for my G3X, and it comes with a 3 conductor shielded cable. The manual calls for the shield to be connected to the backshell at the GSU73. I had planned for a circular connector (CPC) at each wing root. This would require that I cut the OAT cable to connect it through the CPC.
How important is it that the shield have connectivity all the way back to the AHARS (GSU73)? I figure I have 3 choices:
1. Connect the shield to a pin in the CPC
2. Ground the shield at the wing root
3. Don't connect the shield to anything.
Thoughts or suggestions?
Thanks,
Aaron
How important is it that the shield have connectivity all the way back to the AHARS (GSU73)? I figure I have 3 choices:
1. Connect the shield to a pin in the CPC
2. Ground the shield at the wing root
3. Don't connect the shield to anything.
Thoughts or suggestions?
Thanks,
Aaron