mavmitchell
Member
Very excited to get my new G3X Touch installed and running.
Found I was getting intermittent Network Errors on several of the LRU's. Clearly I had a CAN bus problem.
My setup was a string starting at the GSU25, GDU460 etc. etc. then finally a GSA28. Following the detailed guidance in the install manual, I terminated the GSU25 with the Plugin terminator, and the GSA28 with the strap from pins 3 and 4. All the nodes were constructed in the connectors and were no longer than about 2". Should be all good, no such luck.
After much investigation it would appear that one of the terminators must be performed by a GDU. The interconnect diagram does show the GDU terminated but my assumption that this is just the way the diagram was drawn.
After removing the terminator off the GSU25 and terminating the GDU460 leaving a node of about 6", all seems ok, no more network errors.
I wasn't able to find anywhere in the install document indicating a requirement that the GDU must be a terminator.
Am I missing something in the document?
Found I was getting intermittent Network Errors on several of the LRU's. Clearly I had a CAN bus problem.
My setup was a string starting at the GSU25, GDU460 etc. etc. then finally a GSA28. Following the detailed guidance in the install manual, I terminated the GSU25 with the Plugin terminator, and the GSA28 with the strap from pins 3 and 4. All the nodes were constructed in the connectors and were no longer than about 2". Should be all good, no such luck.
After much investigation it would appear that one of the terminators must be performed by a GDU. The interconnect diagram does show the GDU terminated but my assumption that this is just the way the diagram was drawn.
After removing the terminator off the GSU25 and terminating the GDU460 leaving a node of about 6", all seems ok, no more network errors.
I wasn't able to find anywhere in the install document indicating a requirement that the GDU must be a terminator.
Am I missing something in the document?