Relentless
Well Known Member
On top of all the other projects I have been managing I feel like I hit a huge milestone today. I put finishing touches on our R360 that will start ASTM 150 test next week. We hope if all goes well this configuration with be certified and can then go into ASTM airframes. Not a big opportunity for the Van's world but it is one huge step in our efforts to show the performance and reliability of this totally new engine technology.
Enjoy
Titan R360 ASTM Certified Configuration
This engine all in weighs less than 250 lbs and puts out 208hp @2750.
Notice the Lite Weight AFP 150 servo tucked in the ACE cold air pressure recovery sump.
The back is super clean with the ECi magnesium accessory case. Leaves lots of room behind the engine.. Also note the pop off valve on the bottom of sump. This can be swapped with the servo position so this engine can direct install into say an updraft configured RV....
Enjoy
Titan R360 ASTM Certified Configuration
This engine all in weighs less than 250 lbs and puts out 208hp @2750.
Notice the Lite Weight AFP 150 servo tucked in the ACE cold air pressure recovery sump.
The back is super clean with the ECi magnesium accessory case. Leaves lots of room behind the engine.. Also note the pop off valve on the bottom of sump. This can be swapped with the servo position so this engine can direct install into say an updraft configured RV....