AirbusPilot
Well Known Member
Hi,
Yesterday I was riveting the center spar and I found that the holes from right F-804G-1 do not much, We tried everything, both F-804G-1 fits perfect on the left side but no in the right. Like I should not drill this holes again in the center spar, because they suppose to match with my wings. I am thinking that the solution will be just to remove 1,5 mm from the top of F-804G-1 and the holes will fit perfect, but my question is would be ok to do this or that will make my center spar to be weaker???
I will be waiting for your advises
Yesterday I was riveting the center spar and I found that the holes from right F-804G-1 do not much, We tried everything, both F-804G-1 fits perfect on the left side but no in the right. Like I should not drill this holes again in the center spar, because they suppose to match with my wings. I am thinking that the solution will be just to remove 1,5 mm from the top of F-804G-1 and the holes will fit perfect, but my question is would be ok to do this or that will make my center spar to be weaker???
I will be waiting for your advises
Last edited: