I cut the E 614 counter balance weight to plan specifications (elevator section page 9-15). The weight still comes in contact with the elevator counter balance skin rivets. So questions:
Do I trim enough off the counter balance weights needed to clear the rivets
Should I squeeze the rivet slightly more (its within tolerance as is)
Is there a minimum weight requirement for the counter balance weights for stability. Are they weight sensitive.
Should the four counterbalance weight, on a scale, be trimmed so they all weight the same.
Thanks.
Do I trim enough off the counter balance weights needed to clear the rivets
Should I squeeze the rivet slightly more (its within tolerance as is)
Is there a minimum weight requirement for the counter balance weights for stability. Are they weight sensitive.
Should the four counterbalance weight, on a scale, be trimmed so they all weight the same.
Thanks.