Good afternoon, I am building a wiring harness using 2 Dynon SV-Com-425 (Com 1 and Com 2) and PS Engineering PDA 360EX. If any one in the group has ever used these two manufactures before in this configuration, I would appreciate a bit of help getting the wiring to match up.
The Dynon specific wiring is clean and understandable along with the PDA 360EX. My biggest question is what to do with connector J1 Pin 9,10,11 and 12 with Dynons Pin 1,2,5,9and 10. At first glance it seemed like no problem till I needed to commit to putting pins in holes.
hopefully getting a fresh set of Eyes on this question will clear things up
Thanks in advance
Robert
The Dynon specific wiring is clean and understandable along with the PDA 360EX. My biggest question is what to do with connector J1 Pin 9,10,11 and 12 with Dynons Pin 1,2,5,9and 10. At first glance it seemed like no problem till I needed to commit to putting pins in holes.
hopefully getting a fresh set of Eyes on this question will clear things up
Thanks in advance
Robert
