polishpilot
Well Known Member
I have a 9A and I am ready to cut the aft edge of the top cowl. My confusion is an instruction from Van's on page 12-4 in his manual.
"Block the forward end UP to be 1/8" to 3/16" BELOW the spinner to allow for future engine sag." (CAPS are mine)
Question is: shouldn't this be above the spinner to allow for sag?
Or am I not getting the picture.
Jim
"Block the forward end UP to be 1/8" to 3/16" BELOW the spinner to allow for future engine sag." (CAPS are mine)
Question is: shouldn't this be above the spinner to allow for sag?
Or am I not getting the picture.
Jim