MartySantic
Well Known Member
Working on the Condition Inspection. See the photo. The hose from the top of the radiator to the reservoir is resting on the engine mount and abrading. You can see the rubber smudges on the mount. Maybe a mil is worn on the underside of the radiator line.
Some type of clamp will be required to hold the hose in position. Ideas?
And before anyone notices, I had to remove the engine mount bolt on the left/top to relieve the washer, as it was in contact with the mount as mentioned in a previous post. The top/right was OK. The two bottom washers are close but also OK.
Some type of clamp will be required to hold the hose in position. Ideas?
And before anyone notices, I had to remove the engine mount bolt on the left/top to relieve the washer, as it was in contact with the mount as mentioned in a previous post. The top/right was OK. The two bottom washers are close but also OK.
Last edited: