Page 10-23 step 3:
Says to assemble the bell crank to the bellcrank angles using AN4-11A bolts. The AN4 bolt does not fit in the angle. I can screw the bolt into the depicted hole (tight) but the unthreaded part of the bolt shank is too big to fit. I went back to page 10-9 step 5 to see if I missed something. NOPE..Not that I can see.
Obviously the hole needs to be a hair bigger. Did I miss a step or is this a missing step?
Looking for advise. Thanks
Says to assemble the bell crank to the bellcrank angles using AN4-11A bolts. The AN4 bolt does not fit in the angle. I can screw the bolt into the depicted hole (tight) but the unthreaded part of the bolt shank is too big to fit. I went back to page 10-9 step 5 to see if I missed something. NOPE..Not that I can see.
Obviously the hole needs to be a hair bigger. Did I miss a step or is this a missing step?
Looking for advise. Thanks