tonyjohnson
Well Known Member
I am stumped on a baffle issue. I now understand the posts here that complain about the instructions that come with the baffle kit, even the new ones.
The instructions say to make part 10SF from angle, 3 1/4 in long. It is described as the aft outboard support fitting at the back of part 10S. I made both part 10S and 10SF as instructed. I cannot determine from the plans how they go together. I note that the aft end of Part 10S seems to be tapered on the drawings, but there is no description of how to make that taper or interface parts 10S and 10SF.
Any help in understanding that issue would be appreciated.
The instructions say to make part 10SF from angle, 3 1/4 in long. It is described as the aft outboard support fitting at the back of part 10S. I made both part 10S and 10SF as instructed. I cannot determine from the plans how they go together. I note that the aft end of Part 10S seems to be tapered on the drawings, but there is no description of how to make that taper or interface parts 10S and 10SF.
Any help in understanding that issue would be appreciated.