RV4er
Well Known Member
I?m ready to hang the engine on my conical mount RV-4. However, there is not enough clearance between the firewall and the two lower engine mounts to install the bolts from back to front. To do this I would have to take the engine mount off, install the bolts, and then re install the mount.
I read back through the manual and looked at the prints and saw nothing about this. Anybody else run up against this? I?m thinking about just installing the lower bolts backwards.
I read back through the manual and looked at the prints and saw nothing about this. Anybody else run up against this? I?m thinking about just installing the lower bolts backwards.