Buggsy2
Well Known Member
On DWG 20, location 2E, the plan says:
Note 5 says:
My question is, what are "angle rivets"? Or is "angle" a verb, and telling the builder to angle the rivets while installing?
These 3 or 4 rivets seem to be impossible to install. Not even a pull rivet with the squeezer will fit in there. The only way seems to be to cut away some of the aft end of F?721B aft canopy deck. But that doesn't seem right.
AN470AD4?7
ALL F?705D BLKHD SIDE CHANNEL
TO F?705E BULKHEAD SIDE DBLR
TO F?705F CHANNEL TO F?705G
ANGLE RIVETS (SEE NOTE 5)
Note 5 says:
Well it is now time to rivet these (I do have a tip-up).NOTE 5: TIP?UP CANOPY ONLY.
DO NOT RIVET UNTIL SIDE SKINS
ARE INSTALLED. DRILL AND CLECO ONLY.
My question is, what are "angle rivets"? Or is "angle" a verb, and telling the builder to angle the rivets while installing?
These 3 or 4 rivets seem to be impossible to install. Not even a pull rivet with the squeezer will fit in there. The only way seems to be to cut away some of the aft end of F?721B aft canopy deck. But that doesn't seem right.