Tiger Driver
I'm New Here
Hello all, I'm a new builder of sn74261 working on the horizontal stabilizer. Everything has been going well until tonight and I think I may have ruined my 702 spars. I'm getting ready rivet the and was test fitting one last time before I prime and start riveting. I noticed the rivet would not pass through the 714-702-405 combo easily so I ran the reamer through... And now the hole in the 702 is "slightly" elongated in the one hole. :-( all others on the 702-714 are snug.
Question, when the rivet is squeezed will it fill the hole? Is this a replacement issue... Everything including the 714/710 edge distance etc looks great.
Dave
Littleton, CO
Question, when the rivet is squeezed will it fill the hole? Is this a replacement issue... Everything including the 714/710 edge distance etc looks great.
Dave
Littleton, CO