On page 32-04 of the plans the builder is instructed to cut two F-1264 control stick pushrods from a piece of AT6-058 x 5/16 tube. The plans show threads on the ends of the pushrods but there is no call out on my plans for the tap thread size required (I?m assuming it is 1/4 - 28) or drill size needed prior to tapping.
I?ve recently moved the shop to the airport and wondering if I?m using the right tube or have I have misplaced a pre-threaded tube? If I am using the correct tubing, where is the callout for the tap and drill sizes?
Thanks,
I?ve recently moved the shop to the airport and wondering if I?m using the right tube or have I have misplaced a pre-threaded tube? If I am using the correct tubing, where is the callout for the tap and drill sizes?
Thanks,