I just had a panel upgrade with the following equipment (among others):
G3X (GDU 460)
GNX 375 WAAS Navigator/ADS-B Transponder
GTR 20 Remote Comm radio - set to Comm 1
SL-30 Nav/Comm radio - set to Comm 2 and Nav 2
I have a couple of questions. First, I can program the standby frequencies for the SL-30 on the G3X CNS Data Bar, but I can't switch the standby to active there. I have to do the switch on the SL-30 itself. Is there something else that needs to be done to allow this switch to happen on the G3X, or is that just a limitation of the older nature of the SL-30?
Second, on the GTX 375, I can pull up the frequencies for a waypoint in the flight plan, but pressing on the frequency on the GTX 375 does not load it to the G3X. Should that be the case? Again, is there something else that needs to be done to make this happen?
G3X (GDU 460)
GNX 375 WAAS Navigator/ADS-B Transponder
GTR 20 Remote Comm radio - set to Comm 1
SL-30 Nav/Comm radio - set to Comm 2 and Nav 2
I have a couple of questions. First, I can program the standby frequencies for the SL-30 on the G3X CNS Data Bar, but I can't switch the standby to active there. I have to do the switch on the SL-30 itself. Is there something else that needs to be done to allow this switch to happen on the G3X, or is that just a limitation of the older nature of the SL-30?
Second, on the GTX 375, I can pull up the frequencies for a waypoint in the flight plan, but pressing on the frequency on the GTX 375 does not load it to the G3X. Should that be the case? Again, is there something else that needs to be done to make this happen?
Last edited: