I’ve just finished installing a new G3X Touch panel which includes new Garmin autopilot servos and have run into a problem I’m unable to resolve. Power for the trim motors comes from the Garmin autopilot servos. The pitch trim motor works fine, however, the roll trim motor doesn’t work. I’ve checked the G3X configuration pages for both the autopilot and trim and don’t see any issues. Additionally, I’ve confirmed there’s power coming from the 2 wire power cable when the control stick buttons are pressed. Lastly, I also confirmed the roll trim servo itself is working ok by using a separate 12v power supply attached to the servo power leads (the servo functioned fine in both directions).
I’ve run out of ideas where to test next and welcome any suggestions.
thanks in advance!
Mike
I’ve run out of ideas where to test next and welcome any suggestions.
thanks in advance!
Mike