So my buddy at work comes through again with his engineering design prowess. This one was a little tougher than the EarthX battery cap, but came out great.
I always end up trying to find cup holders in the car to hold my phone and wallet so I decided on the RV10 to design a 3D printed insert for the center console to hold an iPad mini in an otterbox case and two cell phones (or 1 phone and a wallet). In front of the slot are going to be the left and right seat heat switches and a USB port. Will keep the engine control knobs on the center console.
I imagine my friend at work would be fine with sharing the file again if someone is interested, but he tells me printing on the angle and finishing the top was a bit harder than he expected and more labor intensive.
I always end up trying to find cup holders in the car to hold my phone and wallet so I decided on the RV10 to design a 3D printed insert for the center console to hold an iPad mini in an otterbox case and two cell phones (or 1 phone and a wallet). In front of the slot are going to be the left and right seat heat switches and a USB port. Will keep the engine control knobs on the center console.
I imagine my friend at work would be fine with sharing the file again if someone is interested, but he tells me printing on the angle and finishing the top was a bit harder than he expected and more labor intensive.