Hi together,
Today I prepared everything for riveting the rear upper skin on my -8.
I found that the control cables for the rudder rubbing on the lower longeron at the rear section of the fuselage. I've checked the manual but found nothing .
Is it okay to install a simple edge guard on the longeron? Iam looking for a simple solution.
Second question. Is there a proposed rivet sequence? I would start with all bulkheads an go then to the longerons.
Thanks to all
Today I prepared everything for riveting the rear upper skin on my -8.
I found that the control cables for the rudder rubbing on the lower longeron at the rear section of the fuselage. I've checked the manual but found nothing .
Is it okay to install a simple edge guard on the longeron? Iam looking for a simple solution.
Second question. Is there a proposed rivet sequence? I would start with all bulkheads an go then to the longerons.
Thanks to all