Hi Folks,
This is for RV-8 Quickbuilt Fuselage. I am finding that the rudder cables brush against the lower longerons in fuselate, if I route the rudder cables as shown in plans (and according to the pre-drilled holes).
Here are a couple of pictures that show the problem:
Any suggestions on how to deal with it? Did anyone else face this problem?
Thanks in advance,
Ashish
This is for RV-8 Quickbuilt Fuselage. I am finding that the rudder cables brush against the lower longerons in fuselate, if I route the rudder cables as shown in plans (and according to the pre-drilled holes).
Here are a couple of pictures that show the problem:
Any suggestions on how to deal with it? Did anyone else face this problem?
Thanks in advance,
Ashish