Planning my wing wiring and notice that the G3X manual on page 21-3 calls for the sheild of the GTP59 wire to be attached to a 16 AWG wire and then the backshell.
I would like to split this cable at the wing root with a CPC connector - but the 16AWG wire will mean it needs to go into large pin connector.
I notice the power wire to the temp probe is not anywhere near this big - does anyone know why i cant use a 22AWG wire for this shield pass through the connector (and at the dsub end to the AHARS)?
I would like to split this cable at the wing root with a CPC connector - but the 16AWG wire will mean it needs to go into large pin connector.
I notice the power wire to the temp probe is not anywhere near this big - does anyone know why i cant use a 22AWG wire for this shield pass through the connector (and at the dsub end to the AHARS)?