RudiGreyling
Well Known Member
Hi Guys,
I have read all 18 post to date in the "Autopilots" forum category, and I am still not clear how and where the servos go for the wing leveler or the altitude hold, and what is required in the installation.
I am new to Auto Pilots, so I think starting this thread will help other newbies as well.
1) Can you guys please explain where and how these APs get installed, hopefully you have some pictures?
2) If you add it while you are in the build stage where do you put them?
3) If you add them after you have been flying where do you put them?
4) What is the differces between the servos available (brushless, engaging gearset, etc etc)?
Thanks in advance,
Kind Regards
Rudi
PS: I am about to close my wings, so I'd like to add what I need now already, but not buy the full AP at this stage.
I have read all 18 post to date in the "Autopilots" forum category, and I am still not clear how and where the servos go for the wing leveler or the altitude hold, and what is required in the installation.
I am new to Auto Pilots, so I think starting this thread will help other newbies as well.
1) Can you guys please explain where and how these APs get installed, hopefully you have some pictures?
2) If you add it while you are in the build stage where do you put them?
3) If you add them after you have been flying where do you put them?
4) What is the differces between the servos available (brushless, engaging gearset, etc etc)?
Thanks in advance,
Kind Regards
Rudi
PS: I am about to close my wings, so I'd like to add what I need now already, but not buy the full AP at this stage.
Last edited: