Jim C. special tools

I have the good fortune of living about 2 hours drive from Blue Ribbon airpark where Jim Cone makes his home, and I contacted him and he invited me up to tour his RV-12 project which is a lot further along than most of us. A lot of tips and information were given including viewing some tools that Jim made up to help in the tight spots. I have taken the liberty of sketching them up and am posting a drawing here in the forum.


Thanks Jim,
Tony

Those are two real good ideas......and appear simple to make. Thanks Tony. Thanks Jim!!

I wish I had seen this a week ago

I just bought a set of the washer insertion tools. they are well made, but were expensive. For the one size that I needed, this would have been a great, and inexpensive project. I will make the nut tool at least.