I'm considering installing one of the AOA systems into my RV4. I would probably mount the indicator in the center of the canopy on the lip. This would save cutting into a panel that is already full and would still look neat.
Would anybody have any recommendations on what system to buy or not
too buy?
Between using ports on the top and bottom of the wing that could allow moisture in, leading edge vanes similar to a conventional stall Warner, probes and hinged type wing similar to the airliners there are many choices.
Considering the plane is already finished and I had bought it built and flying.
How difficult will it be to try to run the plastic lines from the wing back to the cabin? I'm thinking that's going to be the most difficult part.
Thanks
Tim
Would anybody have any recommendations on what system to buy or not
too buy?
Between using ports on the top and bottom of the wing that could allow moisture in, leading edge vanes similar to a conventional stall Warner, probes and hinged type wing similar to the airliners there are many choices.
Considering the plane is already finished and I had bought it built and flying.
How difficult will it be to try to run the plastic lines from the wing back to the cabin? I'm thinking that's going to be the most difficult part.
Thanks
Tim