gmcjetpilot
Well Known Member
I am looking at the two cabin heat stainless versions, spot welded not assembled with aluminum hardware for my RV-7 (listed below).
Also what is the throw or travel to move the flap from closed to open?
Comments, suggestions pictures, lessons learned, do and don't?
Did you use cable control or servo to move?
I am looking at are (spruce aircraft)
"HEATER BYPASS VALVE WITH ENGINE SIDE CONTROL LEVER"
Part # 08-01311-1
"HEATER BYPASS VALVE WITH CABIN SIDE CONTROL LEVER FOR RV-7, RV-8 AND RV-9"
Part # 08-01311 (I like this one, looks light, simple and effective)
Both are wedged shape not boxes... figure this will work fine and take less room.
Also what is the throw or travel to move the flap from closed to open?
Comments, suggestions pictures, lessons learned, do and don't?
Did you use cable control or servo to move?
I am looking at are (spruce aircraft)
"HEATER BYPASS VALVE WITH ENGINE SIDE CONTROL LEVER"
Part # 08-01311-1
"HEATER BYPASS VALVE WITH CABIN SIDE CONTROL LEVER FOR RV-7, RV-8 AND RV-9"
Part # 08-01311 (I like this one, looks light, simple and effective)
Both are wedged shape not boxes... figure this will work fine and take less room.
Last edited: