What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

F-01410C 1/4 hole Step 4 Pg 10-10

HAL Pilot

Well Known Member
Aloha

Wondering about bolt snugness for these attachment points. I just drilled the 1/4 inch holes but the bolts have a little wiggle to them if I test fit them.

So I pulled out the calipers and the holes are nice 0.250 inches but the bolts are 0.247 so there is a bit of wobble when inserted. I am not an engineer but I would think the horizontal Stab attachment bolts should go in snug and not have any movement. Am I too paranoid here?
 
Last edited:
Back
Top